littlejohn
09-22-2008, 08:26 PM
1989 YJ Sahara-
6cyl runs, has new fuel pump and TFI ignition upgrade.
setup for MC2100, but needs carb.
5spd- swapped out BA10 for a AX15 with matching NP231
NEW LUK clutch- installed less than 1mile ago.
AC blows cold
Driver's seat worn/torn, rest of interior is faded as it has been open to the elements for a while. Dash will clean up nicely w/amor all.
Half doors included
NO TOP, but hardware is there.
2-4" Rough Country SUA lift, with dropped pitman arm.
2-3" body lift.
33" Super Swampers- on rusty wheels- plenty of tread left
Windshild frame is rusted below glass-
Both front fenders are dented.
Tub has some rust on cowl, but nothing that can't be ground off.
Rear axle is toast, there was water in the housing, bearings are shot.
This is an excellent start for a beater or trail rig.
I have too many projects, and need $$$ for CJ cam, intake & carb mods.
Will post pics asap.
6cyl runs, has new fuel pump and TFI ignition upgrade.
setup for MC2100, but needs carb.
5spd- swapped out BA10 for a AX15 with matching NP231
NEW LUK clutch- installed less than 1mile ago.
AC blows cold
Driver's seat worn/torn, rest of interior is faded as it has been open to the elements for a while. Dash will clean up nicely w/amor all.
Half doors included
NO TOP, but hardware is there.
2-4" Rough Country SUA lift, with dropped pitman arm.
2-3" body lift.
33" Super Swampers- on rusty wheels- plenty of tread left
Windshild frame is rusted below glass-
Both front fenders are dented.
Tub has some rust on cowl, but nothing that can't be ground off.
Rear axle is toast, there was water in the housing, bearings are shot.
This is an excellent start for a beater or trail rig.
I have too many projects, and need $$$ for CJ cam, intake & carb mods.
Will post pics asap.